DESCRIPTIONDocument No. VALUERAM1445-001.D00 05/10/21 Page 1SPECIFICATIONSFEATURESThis document describes ValueRAM's 1G x 64-bit (8GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM) 2Rx8, memorymodule, based on sixteen 512M x 8-bit FBGA components. TheSPD is programmed to JEDEC standard latency DDR3-1600timing of 11-11-11 at 1.5V. This 240-pin DIMM uses goldcontact fingers. The electrical and mechanical specificationsare as follows:• JEDEC standard 1.5V Power Supply• VDDQ = 1.5V• 800MHz fCK for 1600Mb/sec/pin• 8 independent internal banks• Programmable CAS latency: 11, 10, 9, 8, 7, 6• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock• 8-bit pre-fetch• Burst Length: 8 (interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write (either on the fly using A12 or MRS)• Bi-directional Differential Data Strobe• Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%)• On Die Termination using ODT pin• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°Cº• Asynchronous Reset• PCB: Height 0.740” (18.75mm) or 1.180” (30.00mm)